Skip to main content
All CollectionsSensorsSensors - Hardware and Troubleshooting
LoRaWAN Gateway & Sensor Setup Guide - How to install your Gateway.
LoRaWAN Gateway & Sensor Setup Guide - How to install your Gateway.
Curtis Nash avatar
Written by Curtis Nash
Updated over a week ago

Attached is the LoRaWAN Gateway & Sensor Setup Guide in .pdf format
​

Install Gateway

Instructions:

  1. Attach antennas

    1. Screw the two small antennas into each of the two 2.4/5 GHz ports. Screw the large antenna into the 868 MHz 900 MHz port.
      ​

  2. Connect Gateway power and ethernet cables

    1. Plug the power cord into the front of the gateway and plug the power adapter into a wall outlet. Next, plug the ethernet cable into its port on the front of the gateway.

  3. Plug ethernet cable into router or network switch

    1. Plug the power cord into the front of the gateway and plug the power adapter into a wall outlet. Next, plug the ethernet cable into its port on the front of the gateway.
      ​

  4. Verify setup and align antennas

    1. Verify that your gateway is set up by checking the lights on top. The POWER and LoRa lights should be on and solid. The ETHERNET light should be on and may be flashing periodically.

IMPORTANT: Ensure that the antennas are pointing either directly up toward the sky or down toward the ground.

Did this answer your question?