Install and Connect Hubs and Sensors to regulate temperatures. (i.e. fridges, freezers)
If the sensor is placed in a walk-in refrigerator or freezer, it must be placed directly outside the unit and as close to the sensor as it can be. If possible, the preferred placement is to have the hub and sensor placed "back-to-back" on each side of the wall.
Once this is done it can be configured through Wi-Fi to sync content to the Jolt Web Portal.
For computer setup refer to the article, Configure Hub From Web Portal.
For smart device setup refer to the article Configure Hub From Device.
Install the Hub
1. Plug the power cord into the sensor hub and outlet. The sensor hub will automatically turn on when plugged in.
a. This can take up to 30 seconds.
2. Place the hub in a low traffic area and close to the sensor.
a. A command strip is included with the hub.